Start with the hardest assembly
Bring the largest panel, the most crowded feeder list and the tallest or most awkward component. Note the transfer direction and which edge the line uses as a reference. Board dimensions in a brochure define an initial screen. A fixture, overhanging component or long unsupported panel can still prevent a reliable transfer.
Compare the board and feeder constraints separately
ETON lists a maximum board of 500 × 450 mm for YT10S. Its larger component envelope depends on an optional fixed camera. Mycronic documents the T1000 conveyor option for A41DX and a different reel arrangement. Ask for the physical conveyor and feeder map before comparing those platforms. A sheet that adds up reel widths without reserving space for installed trays or wide feeders overstates capacity.
Use a different trial for lighting lenses
FARoad describes CPM-F2T as a lens placement machine for lighting assemblies. Demonstrate orientation, pickup contact and placement offset using the actual lens and feed media. A cycle that runs with ordinary tape-fed components cannot establish repeatability on a lens that turns or scratches during feeding.
Check the soldering handoff
If the board goes into a BTU Pyramax 125N, verify that its rail support and transfer height suit the board as it leaves placement. Agree a loaded-board profile and the atmosphere required by the process. For accessible joints assigned to a UNIX-DF404S point-soldering station, bring the actual fixture and check tip access, wire feed and joint quality. Qualify each process on its own joints.
Record a comparable cycle
Time a stable run from board arrival to discharge. Include fiducial alignment, replenishment and any reject or recovery steps. Repeat after a short changeover. Record placements per board and elapsed time so the buyer can compare boards per hour on the same job.
Define the handoff for a quote
Attach the board drawing, BOM and feeder matrix. Ask for model and serial evidence, installed vision and transport options, and the trial result for each edge case. Keep unresolved feeder supply, software and installation questions visible in the offer.





